How to resize a ring at home
Through the years, your ring may not perfectly fit anymore due to the changes in your body. It can be loose or a bit tight.
Having a ring that’s too tight may result in the blockage of the blood circulation around your ring finger. On the other hand, wearing a loose ring may sometimes cause it to accidentally fall on the ground without you even knowing.
To avoid such instances, read on to find out ways on how to adjust your ring according to your desired size without visiting local jewellery stores.
Loose rings
Loose rings tend to fall off and spin around your finger—which can be extremely annoying. It can also be stolen by someone you shook hands with. There are many worst-case scenarios in having a loose ring.
Good thing there are ways to reduce the size of your ring to perfectly fit you. Here are some ways:
Plastic guards
This is the safest possible solution if you’re planning on reducing the size of your ring yourself. They’re cheap, widely available and provide a quick solution for rings that easily slip off.
They’re silicone sleeves that you place between your ring and the finger you wear it on. The only problem is that the ring will look odd when worn.
Food grade silicone
This is the DIY counterpart of the plastic guard solution. Instead of wearing a plastic sleeve, just apply a small amount of food grade silicone along the inner side of the ring and let it sit for 24 hours.
The great thing about this method is that the silicone is clear, which makes it unnoticeable. It can also be easily removed. Just gently scrape the adhesive with your fingernails and done! Your ring is back to its original state.
Small beads
With the use of two small beads, you can make your loose ring fit on your finger. All you need to do is apply a small amount of epoxy or food grade silicone on each bead and set them apart inside on the bottom of your ring. Let them sit for 24 hours and your ring is good to go.
Tight rings
Tight rings are painful when worn. It can cause problems on your blood circulation and might lead to other complications as well.
There are two ways in which you can loosen up a tight ring. These are:
Rubber mallet or small hammer
With the use of a small hammer or a rubber mallet, you can gently tap the inside of the ring forcing it to be a bit elongated until it can slide onto your finger seamlessly.
Keep in mind that this is not recommended because it can damage your ring and will cost you a lot.
Professional assistance
If all else fails or you don’t want to ruin your ring, you could always take your ring to the best jewellers in Sydney that offer repairs to avoid further damage.
Be sure to think it through a few times before resorting to these alternatives. Ending up with a misshapen or damaged ring is the last thing you want.
